Omega LVU700 Series - Values Menu; Setup; Diagnostic (DIAG) Parameters

47
Display Appendix (continued) Section Eight
VALUES MENU
Functions include providing setup information (SETUP), a diagnostic to be used in conjunction with a OMEGA
ENGINEERING Representative (DIAG) and the ability to reset the LVU700 series (RESET).
SETUP
Will display the configuration settings for LVU700
series.
1. In TOP-LEVEL MENU mode, select
VALUES.
2. Select SETUP.
3. Setup will list the following information:
a. UNITS,
b. DISPLY,
c. REV MA,
d. SAFE,
e. HEIGHT,
f. FILL-H
g. START UP
4. Select EXIT to return to TOP-LEVEL
MENU.
DIAGNOSTIC (DIAG) PARAMETERS
This mode runs diagnostic tests that confirm
operation of LVU700 series. This is a
production test feature used by the factory to
confirm operation.
1. In TOP-LEVEL MENU, select VALUES.
2. Select DIAG.
3. DIAG will list the following settings:
a. Display Test
b. RANGE
c. TEMP
d. ECHO
e. POWER
f. VER
4. Select EXIT to return to TOP-LEVEL
MENU.
Note: This mode should only be used when
supervised by a OMEGA ENGINEERING
representative.

