80-JB566-1 Rev. G 3-1
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
Installation Planning Regulatory Compliance Information
3
Installation Planning
Regulatory Compliance Information
FCC/IC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le onctionnement.
Caution
This equipment should be installed and operated with minimum 20 cm between the radiator
and body. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter unless authorized to do so by the FCC/IC.
Installation Guidelines
Typical Installation Steps
1. Online Activation (at least one day prior)
2. VTM50 Installation
3. Antenna Installation
4. Display (DIU50) Installation
5. Power/IO and ignition connection
Note: It is recommended to have all components connected to the VTM before applying
power via the Power I/O cable.
6. System verification
To Next Page