Omnitracs MCP50 - VTM LED Indicator; VTM Performance-LED Indicators

80-JB566-1 Rev. G 23-1
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
23
VTM LED Indicator
VTM Performance—LED Indicators
In a normal operating environment, the LED will be OFF.
Other operating modes are shown below:
State VTM indicator Action
Normal Mode OFF None
Sleep Mode OFF None
Boot up and
System Recovery
Mode
A Red LED will blink ON and OFF at
irregular frequencies. Note: this should
last no more than 5 minutes.
Give unit 5 minutes to boot or recover
Under voltage
Mode
A Red LED will blink very quickly Check power source
Scheduler Failure
Mode
A Red LED on solid Test with known-good VTM