2 Installation and connection
2-1 Installation
2-1-1 Rackmount installation (EIA/JIS 19-inch rack/server
rack)
Caution
When performing rack installation, ensure that the UPS is supported and
stabilized by using both the support angles and the table clamps that
were rated.
● When installing on a rack, make sure that the UPS is supported by the each unit
individually.
● When installing on a rack, make sure to use the support angles and table clamps
included with the product. Without the support angles, the front clamp alone cannot
support the weight of the UPS.
●
The mass of each unit: BA100R: Approx. 13 kg.
In a case where the UPS is to be mounted on a rack, place it on the lower
part of the rack.
● Dropping it may result in injury.
Be sure to use the supplied mounting screws.
● Use of long screws other
than those supplied for case mounting may damage
inside the unit.
● When installing on a rack, make sure to use the support angles and table clamps
included with the product. Without the support angles, the front clamp alone cannot
support the weight of the UPS.
●
Screws other than those supplied may not be strong enough to support the UPS,
causing it to fall.
■
Items included in the 19-inch rack support angle mounting bracket set (BAP100RS)
Rack rail (front) L ................................................................. 1
Rack rail (front) R ................................................................ 1
Rack rail (rear)..................................................................... 2
Ear brackets ........................................................................ 2
Rail length fixing screws (M4 x 8) ........................................ 4
Ear bracket mounting flat-head screws (M3 x 6) ................. 8
EIA/JIS rack fixing screws (M5 x 16) ................................... 10
JIS rack fixing flat-head screws (M5 x 14) ........................... 2
EIA rack fixing nuts (M5) ..................................................... 10
BA75T/BA100T/BA100R
24
To Next Page
Loading...
