Omron BCM-500 - 9. Select Your User ID and Take a Measurement

14
Operating instructions
9. Select Your User ID and Take a
Measurement
If your user ID is not recognized automatically, you can select your user ID manually and take the
measurement as follows.
1.
Press the button to turn on the power.
The power turns on. User ID “1” blinks.
2.
Select your user ID.
Select your user ID with the button.
When the birth date ( ) is displayed, your personal data has not been
set-up in your user ID.
Set-up your personal data. (Refer to
Section 5.)
3.
Press the button to conrm your user ID.
“0.0 lb” is displayed.
4.
Take a measurement when “0.0 lb” is displayed.
Step onto your monitor.
5.
Check your measurement results.
Your results will automatically rotate on the display.
6.
Press the button (2 seconds or longer) to turn off the power.
The power turns off if your monitor is not used for 3 minutes.