Omron BCM-500 - 4. Set the Measurement Unit, Date and Time

8
Before using your monitor
4. Set the Measurement Unit, Date and Time
Settingthemeasurementunit,dateandtimeisnecessarybeforetakingameasurementfortherst
time or after replacing the batteries.
• The date and time will be automatically set when paired with your smart device. To set manually,
follow the instructions below.
1.
Press the button to turn on the power.
“inchlb” blinks on the display.
2.
Set the measurement unit.
Press the button to adjust and press the buttontoconrm.
• The default measurement unit is “lb & inch”.
• You can set the measurement unit to “st-lb & inch” or “kg & cm”.
3.
Set the date and time on your monitor.
Press the button to adjust and press the buttontoconrm.
• Setting range of year: 2019 to 2045.
• Time is a 12-hour clock.
• While setting the year, date, hour and minute, hold down the
button to
advance rapidly in increments of 10.
After all the settings for the measurement unit, year, month, day, hour and
minute are displayed in that sequence, the power automatically turns off.
NOTES
• If any mistake is made during the setting, press the
button (2 seconds or
longer) to turn off the power and start from “Step 1” again.
• If, when setting-up the measurement unit, date and time, this monitor is not used for 3 minutes, the
power will automatically turn off. If this happens, the information entered during set-up will not have
been saved. Please proceed again to set-up measurement unit, date and time again.
• To modify the measurement unit, date or time, remove the batteries and wait for at least 20 seconds.
Then insert the batteries and reset again.
Year
Month
Day