Omron DEVICENET#05-2003 - Page 154

144
Analog Output Units Section 5-2
The voltage output or current output will be output on the output terminal
on the Analog Output Unit designated in step 7. Adjust the slider bar until
the output is correct for 0%.
9. Click Fix Offset Value when the voltage output or current output is correct
for 0%.
The offset value set using the slider bar will be stored in the EEPROM in
the Analog Output Unit. Reset the Unit to enable the new setting.
10. Drag the Gain Output Slider Bar to adjust the value, then click Set.
The voltage output or current output will be output on the output terminal
on the Analog Output Unit designated in step 7. Adjust the slider bar until
the output is correct for 100%.