Omron DEVICENET#05-2003 - GT1-ID16 DS Transistor Input Unit with Connector (NPN)

57
Transistor Input Units Section 4-3
Cables with Connectors
When a Transistor Input Unit with a high-density connector is to be connected
to an OMRON I/O Block or a Connector-Terminal Block Conversion Unit, use
the cables listed in the following table (sold separately).
Dimensions
Note The vertical center of the Unit is 4.9 mm lower than the center of the DIN
track. The Unit therefore extends downward 41.4 mm (including the mounting
hook) from the DIN track center.
4-3-7 GT1-ID16DS Transistor Input Unit with Connector (NPN)
Input Specifications
Note The number of input points that can be ON simultaneously depends
on the ambient temperature, as shown below.
Manufacturer Model number Device
OMRON XW2Z-@@@A Connector-Terminal Block Conversion
Unit
XW2B-20G4 or
XW2B-20G5
(Unit: mm)
Approx. 59
Item Specifications
Number of input points 16 points
Number of points that can be ON simultaneously 16 points max.
Max. No. of input points
Ambient temperature (°C)