147
Analog Output Units Section 5-2
5. Click Adjustment.
The Unit Adjustment Window will be displayed.
6. Click Set Default.
7. A message asking you to confirm will appear. Click Yes.
The offset and gain settings stored in the EEPROM in the Analog Output
Unit will be reset to the default values. Reset the Unit to enable the default
settings.
8. After clearing the adjustment settings, click Close. A message asking if
you want to reset will appear. Click Yes. The Communications Unit and all
I/O Units connected to it will be reset, and the default settings will be en-
abled.
To Next Page
Loading...
