EasyManua.ls Logo

Omron DEVICENET#05-2003 - Page 159

Omron DEVICENET#05-2003
233 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
149
GT1-TS04T and GT1-TS04P Temperature Input Units Section 5-3
Components
GT1-TS04T
GT1-TS04P
TS Indicator
Shows the communications status of the I/O Unit interface.
Normal communications: Lit green
I/O Unit interface error: Lit red
During initialization, or with no power supply: Not lit
PWR Indicator
Internal power being supplied: Lit green
No internal power supply: Not lit
I/O Unit Interface
Communications Connector 1
(on the Communications Unit side)
Rotary switch
On the left side of the cassette. Used
to set the input type and input range.
DIP Switch
On the left side of the Cassette.
Pin 1: Temperature unit
Pin 2: Number of decimal places used
Pin 3: Reserved for system use (OFF)
Pin 4: Software setting enable/disable
U. ERR Indicator
Unit error: Lit red
Unit normal: Not lit
Cassette
Detach by pressing lightly on the
upper part and pulling outwards.
DIN Track
Mounting Hook
Cold Junction Compensator
Compensates the input temperature.
Do not touch.
I/O Unit Interface
Communications Connector 2
(on the terminator side)
TS Indicator
Shows the communications status of the I/O Unit interface.
Normal communications: Lit green
I/O Unit interface error: Lit red
During initialization, or with no power supply: Not lit
PWR Indicator
Internal power being supplied: Lit green
No internal power supply: Not lit
U. ERR Indicator
Unit error: Lit red
Unit normal: Not lit
I/O Unit Interface
Communications Connector 2
(on the terminator side)
Cassette
Detach by pressing lightly on the
upper part and pulling outwards.
Rotary switch
On the left side of the cassette. Used
to set the input type and input range.
I/O Unit Interface
Communications Connector 1
(on the Communications Unit side)
DIP Switch
On the left side of the Cassette.
Pin 1: Temperature unit
Pin 2: Number of decimal places used
Pin 3: Reserved for system use (OFF)
Pin 4: Software setting enable/disable
Terminal Block
Terminal Block
DIN Track Mounting Hook
(Refer to page 200.)
(Refer to page 201.)
(Refer to page 207.)
(Refer to page 107.)
(Refer to page 201.)
(Refer to page 200.)
(Refer to page 107.)
(Refer to page 207.)

Table of Contents

Related product manuals