Omron DEVICENET#05-2003 - Page 223

217
Connectable Devices Appendix B
2. The cables made by Allen-Bradley are stiffer than the cables made by OMRON and Nihon Wire &
Cable Company Ltd., so do not bend the Allen-Bradley cables as much as the others.
Connectors
Connector Screwdriver
Terminating Resistors
Note Also can be used as Terminating Resistor with T-branch Tap.
T-branch Tap
Power Supply Tap
I/O Unit Connecting Cables for MULTIPLE I/O TERMINAL Units
Model Specifications Manufacturer
MSTB2.5/5-ST-5.08AU For node connection
Without connector set screws
(Attach to DRT1-ID08(-1),
-ID16(-1), -OD08(-1), -OD16(-1),
-ID16X(-1), -OD16X(-1),
-HD16S, -ND16S, -AD04,
-AD04H, -DA02, -TS04T,
-TS04P)
Phoenix Contact K.K.
Reference No: 1752399
Model Specifications Manufacturer
SZF-1 Special screwdriver for DeviceNet connectors Phoenix Contact
K.K.
Model Specifications Manufacturer
DRS1-T Terminal-block Terminating Resistor, 121 Ω OMRON
Model Specifications Manufacturer
DCN1-1C 3 connectors provided (When used on trunk
line, 1 drop line can be connected.)
Terminating Resistor can be connected.
OMRON
DCN1-3C 5 connectors provided (When used on trunk
line, 3 drop lines can be connected.)
Terminating Resistor can be connected.
OMRON
Model Specifications Manufacturer
DCN1-1P Power supply 1-branch tap with 2 connectors
(provided)
OMRON
1485T-P2T5-T5 Required when connecting more than one
power supply.
Countercurrent flow prevention, ground termi-
nal provided
Allen-Bradley
Model Specifications Manufacturer
(Provided with I/O Units) Cable length: 40 mm OMRON
(Provided with Communications
Unit)
End connector
GCN1-100 Cable length: 1 m