63
Transistor Input Units Section 4-3
Connector Pin Arrangement
Wiring Attach a FUJITSU connector to the Transistor Input Unit and connect it to the
external devices.
Applicable Connectors
Three types of connectors can be attached to the cable depending on the
assembly method. When creating your own cables, use one of the following
connectors.
Cables with Connectors
When a Transistor Input Unit with a high-density connector is to be connected
to an OMRON I/O Block or a Connector-Terminal Block Conversion Unit, use
the cables listed in the following table (sold separately).
Note Make sure there are no more than 16 points are turned ON at the same time.
Dimensions
Note The vertical center of the Unit is 4.9 mm lower than the center of the DIN
track. The Unit therefore extends downward 41.4 mm (including the mounting
hook) from the DIN track center.
Pin
number
Function
Pin
number
Function
A20 A19 A18 A17 A16 A15 A14 A13 A12 A11 A10 A9 A8 A7 A6 A5 A4 A3 A2 A1
NC NC V
IN IN IN IN IN IN IN IN
V
IN IN IN ININ IN IN IN
15 14 13 12 10 09 0811 06 05 04 03 01 000207
B20 B19 B18 B17 B16 B15 B14 B13 B12 B11 B10 B9 B8 B7 B6 B5 B4 B3 B2 B1
NC NC V
IN IN IN IN IN IN IN IN
V
IN IN IN ININ IN IN IN
15 14 13 12 10 09 0811 06 05 04 03 01 000207
m word
m+1 word
Manufacturer Model number Remarks
FUJITSU FCN361J040-AU Soldered
FCN363J040-AU Crimp
FCN367J040-AU/F Pressure-welded
Manufacturer Model number Device
OMRON XW2Z-@@@B Connector-Terminal Block Conversion
Unit
XW2B-40G4 or
XW2B-40G5
G79-I@C-@ I/O Block
G7TC-I@16
(Unit: mm)
Approx. 70110
60
65
27.6
37.4
12.6
35
4
To Next Page
Loading...
