72
Transistor Output Units Section 4-4
Terminal Arrangement
Connector Pin Arrangement
The following diagram shows the pin arrangement for the connector.
Wiring Attach MOLEX connectors to the Transistor Output Unit and connect them to
external devices.
Applicable Connectors
Wiring Examples
Note V terminals and V connector pins, as well as G terminals and G connector
pins, are internally connected. When the I/O power is being supplied from a
terminal block, the power can be supplied to the output devices from the V
and G connectors. Current supplied in this way, however, must be less than
2A.
Output
Output
Signal
GV
Manufac-
turer
Connector Model number Remarks
MOLEX Pressure-
welded
Housing 521-09-0390 For AWG#24
Crimp Housing 50-57-9403 ---
Reeled contacts 16-02-0069 For AWG#24 to 30
16-02-0086 For AWG#22 to 24
Loose contacts 16-02-0096 For AWG#24 to 30
16-02-0102 For AWG#22 to 24
Crimping tool 570-36-5000 For AWG#22 to 26
11-01-0209 For AWG#24 to 30
I/O power
supply
Solenoids,
valves, etc.
24 VDC
+ −
To Next Page
Loading...
