77
Transistor Output Units Section 4-4
Connector Pin Arrangement
Wiring Attach a FUJITSU connector to the Transistor Output Unit and connect to
external devices.
Applicable Connectors
Three types of connectors can be attached to the cable, depending on the
assembly method. When creating your own cables, use one of the following
connectors.
Connector Cables
When a Transistor Output Unit (connector) is to be connected to an OMRON I/
O Block or a Connector-Terminal Block Conversion Unit, use the cables (sold
separately) listed in the following table.
Note V terminals and G terminals are internally connected. When the I/O power is
being supplied, the power can be supplied to the output devices from the V
and G connectors. Current supplied in this way, however, must be less than
2 A. If, instead of using the V and G connectors, the power supply is wired to
the terminal block as shown in the following diagram, the current supplied
must be less than 2.5 A.
A12
Pin number
Function
Pin number
Function
A11 A10 A9 A8 A7 A6 A5 A4 A3 A2 A1
VNCV
G
OUT OUT OUT OUTOUT OUT OUT OUT
06 05 04 03 01 000207
B12 B11 B10 B9 B8 B7 B6 B5 B4 B3 B2 B1
VNCV
G
OUT OUT OUT OUTOUT OUT OUT OUT
14 13 12 11 09 081015
Manufacturer Model number Remarks
FUJITSU FCN361J024-AU Soldered
FCN363J024-AU Crimp
FCN367J024-AU/F Pressure-welded
Manufacturer Model number Corresponding device
OMRON XW2Z-@@@A Connector-Terminal Block Conversion Unit
XW2B-20G4
XW2B-20G5
G79-@@@C I/O Block
G7TC-OC16
G70D-SOC16
G70D-FOM16
G70A-ZOC16-3
M7F
Output Unit
I/O Block (example)
Load
To Next Page
Loading...
