Omron E5AN-H

207
Adjustment Level Section 5-4
• This parameter sets the output hold interval (the ON/OFF switching inter-
val between the open and close outputs) for position-proportional control.
■ Related Parameters
Open/close hysteresis (adjustment level): Page 207
• This parameter provides hysteresis in position-proportional control when
the open and close outputs are switched ON or OFF.
■ Related Parameters
Position proportional dead band (adjustment level): Page 207
• This parameter sets the extraction of square root low-cut point used for
the inputs. The data after extracting the square root is shown below.
db Position Proportional Dead Band
Position-proportional control must be
supported.
Setting range Unit Default
Position proportional (close):
0.1 to 10.0
%4.0
Position proportional (floating):
0.1 to 10.0
%2.0
Function
Setting
See
See
oc-h Open/Close Hysteresis
Position-proportional control must be
supported.
Setting range Unit Default
0.1 to 20.0 % 0.8
Function
Setting
See
See
sqrp Extraction of Square Root Low-cut Point
The input type must be an analog
input, and the Extraction of Square
Root Enable parameter must be set
to ON.
Function