Omron E5AN-H

256
Advanced Function Setting Level Section 5-10
This parameter sets the shift method for a temperature input.
• When the input type is for a temperature input, set either a 1-point shift or
a 2-point shift.
■ Related Parameters
Temperature input shift, Upper-limit temperature input shift value, Lower-limit
temperature input shift value (adjustment level): Page 199
Input type (initial setting level): Page 224
This parameter sets whether or not the MV at Stop and MV at PV Error
parameters are to be displayed.
• Set whether or not the MV at Stop and MV at PV Error parameters are to
be displayed.
■ Related Parameters
MV at stop, MV at PV error (adjustment level): Page 204
• Set whether the Auto/Manual Switch parameter is to be displayed.
Note For Controllers with a PF Key (E5AN/EN-H), the default is ON.
istp Input Shift Type
The input type must be for a temper-
ature input.
Setting range Default
ins1: 1-point shift, ins2: 2-point shift ins1
Function
Setting
See
See
mvse MV at Stop and Error Addition
The control must be set to 2-PID
control.
Setting range Default
on: Displayed, off: Not displayed off
Function
Setting
See
See
amad Auto/Manual Select Addition
The control must be set to 2-PID
control.
Setting range Default
on: Displayed, off: Not displayed on
Function
Setting