Omron E5AN-H

280
Advanced Function Setting Level Section 5-10
• This parameter resets the ON/OFF counter for specified control outputs.
Note After the counter has been reset, the set value will be automatically returned
to 0.
■ Related Parameters
Control output 1 ON/OFF count monitor, Control output 2 ON/OFF count mon-
itor (advanced function setting level): Page 278
This parameter sets the password to move to the calibration level.
• Set the password to move to the calibration level. The password is 1201.
• Move to the calibration level either by pressing the M Key or O Key or by
waiting for two seconds to elapse.
■ Related Parameter
Initial setting/communications protect (protect level): Page 172
rac ON/OFF Counter Reset
Control outputs 1 and 2 must be sup-
ported.
Relay, or voltage outputs (for driving
SSR), or SSR output must be used.
Setting range Default
0: Disable the counter reset function.
1: Reset the control output 1 ON/OFF counter.
2: Reset the control output 2 ON/OFF counter.
0
Function
Setting
See
See
cmov Move to Calibration Level
Initial setting/communications protect
must be 0.
Function
See
See