84
Operation Level Section 5-3
This parameter is for monitoring the manipulated variable on the control out-
put 2 side during operation.
• This parameter cannot be set.
• During heating/cooling control, the manipulated variable on the control
output 2 side (“ALM 2” terminal output) is monitored.
■ Related parameters
“Standard or heating/cooling” (initial setting level)
“Manipulated variable display” (advanced function setting level)
MV monitor (OUT2)
The control must be heating/cooling
control.
Manipulated variable display must be
set to “ON”.
c-o
Setting Range
Unit Default
Heating/cooling 0.0 to 100.0 %
Function
Monitor
See
To Next Page
Loading...
