Omron E5CJ-R2 User Manual

58
9-3 Engineering Level Parameters
The value set before shipping
appears. (see note 1)
Displayed if the E5J with a com-
munications function is used.
(Data bit length setting)
(Parity check setting)
(Stop bit length setting)
Displayed if the E5J is in advanced
PID operation with fuzzy self-tuning.
(Stable range setting)
Displayed if the E5J is in advanced
PID operation.
(Alpha setting)
(Automatic return of display mode)
Displayed if the E5J with an alarm
function is used (see note 2).
(Standby sequence
reset method setting)
(Input shift display selection)
Displayed if the E5J with an alarm
function is used (see note 2).
(Alarm 1 hysteresis
setting)
Displayed if the E5J with an alarm
function is used (see note 2).
(Alarm 2 hysteresis
setting)
(Set point lower limit setting)
(Set point upper limit setting)
Displayed if the E5J with
event input 2 is used.
(Event input 2 function
selection)
Note: 1. The E5J--F values set before shipping may be
different. Refer to
9-2 Engineering Level Parameter List.
2. The value will not be displayed if the alarm mode switch is
set to 0 or if the E5J does not incorporate any alarm.
(°C/°F selection)
15.0
Engineering Level Parameters
Section 9-3

Omron E5CJ-R2 Specifications

General

Brand	Omron
Model	E5CJ-R2
Category	Temperature Controller
Language	English