CHAPTER 3 BASIC OPERATION
3-1
CHAPTER 3
BASIC OPERATION
CHAPTER3
3.1 Initial Setup Examples 3Ć2.................
3.2 Setting the Input Type 3Ć4.................
Input type 3Ć4.............................
3.3 Selecting
_
C/
_
F 3Ć5........................
Temperature unit 3Ć5......................
3.4 Selecting PID Control or ON/OFF Control 3Ć6..
3.5 Setting Output Specifications 3Ć7...........
Control period 3Ć7.........................
Direct/reverse operation 3Ć7................
3.6 Setting the SP 3Ć9.........................
Changing the SP 3Ć9.......................
3.7 Executing ON/OFF Control 3Ć10.............
ON/OFF Control 3Ć10.......................
Setup 3Ć11.................................
3.8 Determining PID Constants
(AT, ST, manual setup) 3Ć12.................
AT.(autoĆtuning) 3Ć12.......................
ST (selfĆtuning) 3Ć13........................
ST start conditions 3Ć14.....................
ST stable range 3Ć14........................
Manual setup 3Ć15..........................
3.9 Alarm Outputs 3Ć17.........................
Alarm type 3Ć17............................
Alarm value 3Ć18...........................
3.10 Heater Burnout Alarm (HBA) 3Ć19...........
HBA detection 3Ć19.........................
Operating conditions 3Ć19...................
Setup 3Ć20.................................
How to calculate detection
current values 3Ć21.........................
Example 3Ć21..............................
3.11 Requests during Operation 3Ć22..............
To Next Page
Loading...
