Omron E5EN - Page 83

CHAPTER 5 PARAMETERS
5-14
Set point 0
Set point 1
Set point 2
Set point 3
The number of multiĆSP uses" parameter
must be set to either 1" or 2", and the mulĆ
tiĆSP uses" parameter must be set to ON".
!* ()%+)* *+ +! *+ ('"&+* .!& +! %,$+"2 ,&+"'& "* ,*
! -$,* *+ "& +!* ()%+)* &  *$+ / '()+"& +! #/* '& +! )'&+
(&$ ') / -&+ "&(,+
• !& +! *+ ('"&+ !* & !&  +! *+ -$, ' +!* ()%+)* ,))&+$/
*+ / %,$+"2 "* $"&# & !& 
• ,)"& +%()+,) "&(,+ +! "%$ ('"&+ ('*"+"'& "* (&&+ '& +! *$+
*&*')
,)"& &$' "&(,+ +! "%$ ('"&+ ('*"+"'& "* (&&+ '& +! *++"& ' +!
0"%$ ('"&+ ('*"+"'& ()%+)
Setting Range Unit Default
Set point lower limit to set point upper limit EU 0
F $+ ()%+)*
0,%) ' %,$+"2 ,** -& ,&+"'& *++"& $-$ ( 2
0-&+ "&(,+ **" &%&+  -& ,&+"'& *++"& $-$ ( 2
0-&+ "&(,+ **" &%&+  -& ,&+"'& *++"& $-$ ( 2
0,$+"2 ,** -& ,&+"'& *++"& $-$ ( 2
0 '()+"'& $-$ 0&(,+ +/( "&"+"$ *++"& $-$ ( 2
0&(,+ +/( "&"+"$ *++"& $-$ ( 2
Adjustment Level
Function
Comment
See