Omron E5EN - Page 99

CHAPTER 5 PARAMETERS
5-30
MultiĆSP uses
The number of multiĆSP uses" parameter
must be set to 0" on models on which the
option event input unit is not mounted.
&#+ 0&# 6*1)0'8 1/#/ -.*#0#. '/ /#0 0, 6 5,1 !+ /#)#!0 /#0 -,'+0/  0,  5
,-#.0'+% 0&# (#5/ ,+ 0&# $.,+0 -+#) ,$ 0&# !,+0.,))#.
&#+ 0&# ,-0',+ #2#+0 '+-10 1+'0 8 '/ *,1+0#" ,+ 0&#  0&'/ -.*#0#.
!+ # 1/#" 3&#+ 0&# 6+1* #. ,$ *1)0'8 1/#/ -.*#0#. '/ /#0 0, 6 +" 6*1)0'8
1/#/ '/ /#0 0, 
 #0 -,'+0/  0,  !+ # /#)#!0#"
 #0 -,'+0/  0,  !+ # +,0 /#)#!0#"
• #$1)0  
F #)0#" -.*#0#./
61)0'8 ,-#.0',+ )#2#) - 8
61* #. ,$ 1)0'8 1/#/ "2+!#" $1+!0',+ /#00'+% )#2#) - 8
SP ramp set value
ST (selfĆtuning) must be set to OFF".
• &'/ -.*#0#. /-#!'$'#/ 0&# !&+%# .0# "1.'+%  .*- ,-#.0',+ #0 0&# *4'8
*1* -#.*'//' )# !&+%# 3'"0& -#. 1+'0 ,$ 0'*# *'+10# / 0&# 6 .*- /#0 2)1#
,3#2#. +,0# 0&0 3&#+ 0&# 6 .*- /#0 2)1# '/ /#0 0, 6 0&#  .*- $1+!8
0',+ '/ "'/ )#"
• 1.'+% 0#*-#.01.# '+-10 0&# "#!'*) -,'+0 -,/'0',+ ,$ 0&#  .*- /#0 2)1# '/
"#-#+"#+0 ,+ 0&# !1..#+0)5 /#)#!0#" /#+/,. +" "1.'+% +),% '+-10 '0 '/ "#-#+"#+0
,+ /!)'+%
Parameter Setting Range Unit Default
SP ramp set value OFF, 1 to 9999 EU OFF
F #)0#" -.*#0#./
6+-10 05-# - 8 6!)'+% 1--#. )'*'0 6!)'+% ),3#. )'*'0 - 8 6#!'*)
-,'+0 6 - 8 '+'0') /#00'+% )#2#)
Advanced Function Setting Level
Function
Comment
See
Function
Comment
See