Omron FQ2-S Series - Page 302

Command Control
300
FQ2-S/CH User’s Manual
for Communications Settings
REGIMAGE or RID
Acquire Registered Image
This command loads a registered image saved to the SD card or PC Tool as the measurement image.
The registered image is the latest image or a logging image that has been assigned a number between 0 and
999 and has been registered in advance with the Set a Registered Image command.
Set a Registered Image p.271
<Command Format>
<Response Format>
When the Command Is Processed Normally
When the Command Is Not Processed Normally
<Parameter Descriptions>
Registered image number Specifies the image to be loaded as the measurement image.
The image is registered in advance with the Set a Registered Image command and
assigned a number. (0 to 999)
RE CR GIMAGE
ID
or
Registered image number
(3 digits max.)
Delimiter
Delimiter
CR R
Registered image number
(3 digits max.)
Space
(0x20)
Space
(0x20)
Delimiter
CR OK
CR ER
Delimiter
FQ2-S_CH_comm.book 300 ページ ２０１４年６月２６日 木曜日 午前１１時４７分