Reading and Verifying Character Strings
FQ2-S4 User’s Manual
4
Setting Up Inspections
99
Limits to the character
format string
• Each line can have a maximum of 32 characters. There can be a maximum of four lines.
• Characters must be input from line 1. (You cannot skip line 1 and set the character format string starting
with line 2.) If you leave any line blank, the setting for the next line will be moved up to fill it.
• You cannot specify a @ symbol by itself.
• You cannot specify more than one @ symbol consecutively.
• You cannot specify more than eight symbols on one line.
5 Press a line to enter the character format for that line
from the software keyboard that is displayed. Enter
the character format for each line and press the [OK]
Button.
Press [ABC] to enter alphanumeric characters.
6 Press [TEACH] on the lower right of the display.
The detailed parameters for character recognition will be
set automatically according to the specified character for-
mat.
Measurement Parameters That Are Automati-
cally Set by Teaching: p. 103
7 The character string that was successfully recog-
nized according to the specified character format
conditions will be displayed.
Press [Yes] to register the read result in the master data.
The master data contains the character strings that are
registered to verify whether the read character strings
match specific character strings.
Step 4 Verification Conditions: p. 101
8 Press [Back] to end teaching.
Item Description
To Next Page
Loading...
