External Reference Parameters
514
FQ2-S4 User’s Manual
*1 Use the ITEMDATA2 command to set and/or acquire a text string.
2D-code
500 Display
setting
Number of characters
display
Setting/Acqui-
sition
0: OFF
1: ON
1 --- ---
501 Character display Setting/Acqui-
sition
0: OFF
1: ON
1 --- ---
External
refer-
ence
number
Category Data name Setting/Acqui-
sition
Data range Default Expres-
sion text
string
Logged data/
Judgement
parameter
0Mea-
sure-
ment
result
Judgement Acquisition
only
−2: Not measured,
0: Judgement is OK,
1: Judgement is NG,
13: Teaching not performed
error,
14: Figure not registered
error,
15: Out of range error,
−16: Measurement timeout
error
−2 JG Logged data
5 Index No. Acquisition
only
−2: Verification OFF,
or reading error
−1: Verification is NG,
0 to 31: Master data No.
−2 IN ---
6 Num. of characters Acquisition
only
0 to 1024 0 N Logged data
7
*1
Characters Acquisition
only
32 characters max. 0 --- ---
103 Output
parame-
ter
Reflect Setting/Acqui-
sition
0: Yes, 1: No 0 --- ---
121 Verifica-
tion con-
dition
Verified master data Settings/
Acquisition
−1: OFF
0: Verify all master data
1: Verify master data 0
2: Verify master data 1
0 --- ---
122 Partial verif. on/off Settings/
Acquisition
0: None
1: Enable
0 --- ---
123 Last compared digit Settings/
Acquisition
1 to 1024 1024 --- ---
124 First compared digit Settings/
Acquisition
1 to 1024 1 --- ---
125 Output
parame-
ter
String output on/off Settings/
Acquisition
0: None
1: Enable
0 --- ---
126 Error string size (bytes) Settings/
Acquisition
1 to 20 2 --- ---
127
*1
Error string Settings/
Acquisition
20 characters max. NG --- ---
128 Partial output on/off Settings/
Acquisition
0: None
1: Enable
0 --- ---
129 Output last digit Settings/
Acquisition
1 to 1024 1024 --- ---
130 Output first digit Settings/
Acquisition
1 to 1024 1 --- ---
External
refer-
ence
number
Category Data name Setting/Acqui-
sition
Data range Default Expres-
sion text
string
Logged data/
Judgement
parameter
...
To Next Page
Loading...
