Inspecting with the Labeling Inspection Item
194
FQ2-S4 User’s Manual
Reflect in Total Judgement
You can specify whether to reflect the judgement results of an inspection item in the overall judgement. (The
default is to reflect them.)
[Inspect] − [Inspection] − [Add item.] − [Labeling] − [Details] Tab Page − [Output parameter]
Editing the Measurement Region
This section describes how to edit the measurement regions. You can edit the measurement region in the same
way as for a search region.
Changing the Model Registration Region to a Shape Other Than a Rectangle: p. 142
If the measurement region is changed, perform teaching if required.
p. 189
Measurement region
Important
To Next Page
Loading...
