18
4. Operation Procedure
This section describes the operation procedure of FQ2 Simulator.
4.1. How to Start FQ2 Simulator
This section describes how you can start FQ2 Simulator.
1. Double-click the TouchFinder for PC icon.
2. The startup menu window opens.
Confirm the version of TouchFinder for PC. The sample image shown below uses Ver.2.00.
Click the image under Start up the simulator (offline).
Caution
At the first startup of TouchFinder for PC, installation of .NET Framework 3.5 is occasionally
requested. If that happens, refer to At the startup of TouchFinder for PC, a message to re-
quest the installation of .NET Framework 3.5 appears. in “3.3. Troubleshooting” in this man-
ual.
・Match the version of FQ2 Simulator and the FQ2 sensor to be configured. For more details
about restrictions, refer to 2.6. Restrictions in this manual.
To Next Page
Loading...
