110
4. Press the Mode Key to display the ps.ay prescaling value Y (exponent) of
input A setting.
Note The asterisks indicate appropriate values.
Set Value LED Display Model Basic Model
5. Press the Mode Key to display the decp decimal point position setting.
Set Value LED Display Model Basic Model
6. Press the Shift Key to set %%%.%%. The displayed setting will be validated au-
tomatically if no change is made for five seconds. The decp decimal point
position setting will be displayed again.
Set Value LED Display Model Basic Model
7. Press the Escape Key to display the pscl prescaling menu.
Set Value LED Display Model Basic Model
Teaching Function Section 6-1
To Next Page
Loading...
Need help?
General
