68
3. Press the Shift Key to display the prior set value 00 for changing. The PROG
indicator will flash.
Set Value LED Display Model Basic Model
4. Press the Up and Shift Keys to set the value to 15. The input value will be
validated automatically if no change is made for five seconds. The uĆno
communications unit number setting will be displayed again.
Note Press the Mode Key to enter the set value immediately. The next pa-
rameter will be displayed for setting.
Set Value LED Display Model Basic Model
5. Press the Mode Key to display the bps baud rate setting.
Set Value LED Display Model Basic Model
6. Press the Shift Key to display the prior set value 9600 for changing. The
PROG indicator will flash.
Set Value LED Display Model Basic Model
7. Press the Up Key to set the value to 19200. The input will be validated auto-
matically if no change is made for five seconds. The bps baud rate setting
will be displayed again.
Note Press the Mode Key to enter the set value immediately. The next pa-
rameter will be displayed again for setting.
Set Value LED Display Model Basic Model
8. Press the Up Key to enter the set value for setting the next parameter. The
input value will be validated automatically if no change is made for five se-
conds. The bps baud rate setting will be displayed again.
Set Value LED Display Model Basic Model
Setting Mode
Section 4-2
To Next Page
Loading...
Need help?
General
