73
Follow the steps described below to set the process time for averaging measured value
to 4 s.
Set Value LED Display Model Basic Model
1, 2, 3... 1. Press the Mode Key for more than one second while the opt option menu is
displayed. The aUg process time for averaging measured value setting will
appear.
Set Value LED Display Model Basic Model
2. Press the Shift Key to display present set value fast for changing. The
PROG indicator will flash.
Set Value LED Display Model Basic Model
3. Repeatedly press the Up Key until 4 is displayed. The setting will be vali-
dated automatically if no change is made for five seconds. The aUg process
time for averaging measured value setting will be displayed again.
Note Press the Mode Key to enter the displayed setting immediately. The
next parameter will be displayed.
Set Value LED Display Model Basic Model
When no operation is executed for five seconds
Set Value LED Display Model Basic Model
SETTING
EXAMPLE
Setting Mode
Section 4-2
To Next Page
Loading...
Need help?
General
