4-2 1:N Host Connection
4-12
Host Units that Can be Connected to PT’s RS-232C and RS-422A Ports
PLC series
CPU Units with built-in 1:N NT
Link function
CPU Units that can be connected with
Communications Boards or Units
CS Series
CS1G-CPU42/43/44/45-E(V1) (See note 1.)
CS1G-CPU42H/43H/44H/45H (See note 1.)
CS1H-CPU63/64/65/66/67(-V1) (See note 1.)
CS1H-CPU63H/64H/65H/66H/67H (See note 1.)
CJ Series
CJ1G-CPU44 (See note 2.)
CJ1G-CPU45 (See note 2.)
CJ1G-CPU42H/43H/44H/45H (See note 2.)
CJ1H-CPU65H/66H (See note 2.)
C200HE-CPU32(-Z) (See note 3.)
C200HE-CPU42(-Z) (See note 3.)
C200HG-CPU33(-Z) (See note 3.)
C200HG-CPU43(-Z) (See note 3.)
C200HG-CPU53(-Z) (See note 3.)
C200HG-CPU63(-Z) (See note 3.)
C200HX-CPU34(-Z) (See note 3.)
C200HX-CPU44(-Z) (See note 3.)
C200HX-CPU54(-Z) (See note 3.)
C200HX-CPU64(-Z) (See note 3.)
C200HX-CPU65-Z (See note 3.)
C200HX-CPU85-Z (See note 3.)
C Series
CQM1H-CPU51/61 (See note 4.)
Note 1. A CS1W-SCB41 Serial Communications Board is required.
2. A CJ1W-SCU41 Serial Communications Unit is required.
3. A C200HW-COM03-V1 or C200HW-COM06-V1 Communications Board is required.
4. A CQM1H-SCB41 Serial Communications Board is required.
Reference CS-series PLCs with -V1 suffix support high-speed 1:N NT Links as well as normal 1:N NT Links.
CS-series PLCs without the -V1 suffix can also be connected to high-speed 1:N NT Links if the lat-
est Serial Communications Board/Unit is used. Refer to High-speed 1:N NT Link for details. (page
4-20)
Host Settings
The methods for setting each Unit are as follows:
Connecting C-series C200HX/HG/HE(-Z), and CQM1H
PLCs
PLC Setup Area
Write the settings directly from the Programming Device or Support Software (CX-
Programmer, etc.) to the PLC Setup Area (Data Memory) according to the host type and port
used.
To Next Page
Loading...
Need help?
General
