150
Operations in the System Installer Mode Section 6-5
After initialization, the memory switch statuses are as follows.
*
The communications conditions for a bar code reader are initialized as fol-
lows:
Data bits: 7 bits; stop bit: 1 bit; parity: none; flow control: RS/CS.
6-5 Operations in the System Installer Mode
The following functions can be executed in the System Installer mode:
• Setting the display language (see below)
• Clearing/installing the system program (page 151)
• Disabling/enabling display of the System Menu (changing the system set-
tings) (page 153)
• Disabling/enabling writing to the screen data memory (changing the sys-
tem settings) (page 153)
• Clearing screen data (page 154)
For details on calling the System Installer mode, refer to Calling the System
Installer Mode (page 138).
For details, refer to 3-5 Using a Memory Unit.
Memory Switch Status
Start-up Wait Time 00
Key Press Sound ON
Buzzer Sound OFF
Printer Controller ESC/P
Print Method Tone (NT31C only)
Screen Saver Movement Display erased
Screen Saver Start up Time 010
Hist. Disp. Method From New Data
Resume Function OFF
Comm. Auto-return OFF
Time-out Interval 01
Retry Counts 005
Comm. A Method
Host Link (communications speed = 9600 bps)
*
Comm. B Select RS-232C
Comm. B Method None
To Next Page
Loading...
Need help?
General
