161
Setting Conditions for Communications with Host by Using Memory Switches Section 6-7
6-7-2 Setting the Host Link Method
Set the communications conditions for the host link method at serial port A or
serial port B by following the operation from the System Menu shown below.
Select Maintenance Mode.
Select Memory Switch.
Ver 4.12
Display the fourth memory switch screen
by pressing the [↓] (next screen) or [↑]
(previous screen) touch switch.
Press the touch switch corresponding to the
port at which the host link method is to be set
(Comm. A Method or Comm. B Method) to
display the setting option Host Link.
The setting option changes each time the
touch switch is pressed.
To Next Page
Loading...
