152
Operations in the System Installer Mode Section 6-5
Clearing the System
Program
• If Return to Menu is selected, the NT31/NT31C returns to the System
Installer mode menu without clearing the system program.
• If clearance fails, a screen asking whether you wish to try again is dis-
played.
On completion of system program clearance, the NT31/NT31C enters the
standby status for downloading of the system program.
Downloading the System
Program
On normal completion of system program clearance, the standby status for
system program downloading is automatically established.
If Abort is selected during standby for downloading or during downloading, a
screen asking whether you wish to download again is displayed.
When the system program is started, the NT31/NT31C starts up normally. If
no screen data has been registered, an error message will be displayed indi-
cating that screen data hasn’t been registered. Transfer the screen data and
proceed.
Select Download System Program.
Select Yes.
The system program is cleared.
During clearance, the message
Erasing ... is displayed.
Select Run System.
When the NT31/NT31C enters this
status, transmit the system program from
the system installer at the personal
computer.
During downloading, the progress of
transmission is indicated on the
screen.
To Next Page
Loading...
Need help?
General
