174
System Settings Section 6-9
Printers that conform to Epson’s ESC/P 24-J83C (color) printer control
specifications or printers that conform to Epson’s ESC/P 24-J82
(monochrome) control specifications.
• PC-PR201H:
Printers that can emulate the PC-PR201H, made by NEC Corp.
•PCL 5:
Printers that conform to the PCL 5 printer control specifications.
Note that the NT31 can only be used with the monochrome Tone setting and
does not support color printing.
For the NT31, the Print Method is fixed as Tone.
The default (factory) setting is ESC/P.
Reference: • In addition to this setting, NT31C has the Print Method setting (page 175).
• For details on the print function, refer to 2-15-7 Print Function in the Ref-
erence Manual.
Set the printer controller setting by following the menu operation from the Sys-
tem Menu shown below.
To set other memory switches, select the relevant screen using the [ ] (next
screen) or [ ] (previous screen) touch switch, then make the setting.
• To confirm the settings and quit the memory switch setting screen, press
the Quit touch switch. The settings made last will be set and the NT31/
NT31C will return to the MAINTENANCE MODE MENU screen.
Select Maintenance Mode.
Select Memory Switch.
Ver 4.12
Press Printer Controller to display the
required printer type.
The setting option changes each time
the touch switch is pressed.
To Next Page
Loading...
Need help?
General
