196
System Maintenance Section 6-11
• Pressing Abort causes the NT31/NT31C to return to the date and time
display without executing setting (with the previous settings still effective).
Select Maintenance Mode.
Select Calendar Check.
Press Set.
Set the date.
Press Quit.
Ver 4.12
If you are just checking the display, press
Quit at this point; the NT31/NT31C will
return to the MAINTENANCE MODE
MENU screen.
Each of the digits of the year, month, date,
hour, minute, and second settings, and the
day of the week setting, are touch switches:
press these touch switches to change the
corresponding settings.
The clock data is set and the NT31/NT31C
returns to the date and time display.
To Next Page
Loading...
Need help?
General
