180
Setting the Conditions for Communications with the Host by Using the Memory Switches
Section 6-7
Display the fourth memory switch screen by
pressing the [ ] (next screen) or [ ] (previous
screen) touch switch.
Press the touch switch corresponding to the
port at which the NT link (1:N) method is to be
set (“Comm. A Method” or “Comm. B Meth-
od”) to display the setting option “NT Link
(1:N)”.
The setting option changes each time the
touch switch is pressed.
In this example, serial port A is used.
Press the “Set” touch switch to the right of the
port at which the setting has been made.
In this example, serial port A is used.
Press the “Unit No.” touch switch to display
the unit number to be set.
The setting option changes each time the
touch switch is pressed.
In this example, serial port A is used.
Press “Quit”.
The unit number is set.
To Next Page
Loading...
