Omron NT31 - Connecting to the RS-232 C Port at the Host

66
Connecting to the RS-232C Port at the Host
Section 4-1
4-1 Connecting to the RS-232C Port at the Host
The method for connecting between the RS-232C port of the PT and the RS-232C
port of the host is as follows.
The following discussion is focused on the connection method to OMRON PCs
(By using the memory link method, a connection can be made to any arbitrary
RS–232 unit). When making a connection to a host other than OMRON PCs, refer
to the “PC Connection” (V042-E1-
S Direct connection between the RS-232C ports using an RS-232C cable (page
127)
This is the easiest connection method. Depending on the host to which the con-
nection is to be made, it may be possible to use OMRON cables with connectors.
RS-232C cable (max. 15 m)
HostNT31/NT31C
Reference: The CS1 series CPU cannot be connected with the 1:1 connection NT link method.
Use the 1:N connection NT link method instead to make the 1:1 connection. For
details, refer to “NT link (1:N) method” (page 81).