Omron NT31 - Printing the Screen

555
Printing Data and Checking the Printer Status
Section 8-11
8-11-1 Printing the Screen
With the NT31/NT31C, the screen currently displayed can be printed by using ei-
ther of the procedures indicated below.
- By the operation at the PT status control area
- By pressing a touch switch with the “print screen” function.
Printing a Hard Copy by Operation at the PT Status Control Area
When this method is used, an operator can print a hard copy of the screen at any
time.
Reserved for system use
PC NT31/NT31C
PT status control area
Screen switch setting
PT status control setting
Copy memory
table setting
Printing
Reference - The NT31/NT31C continues operation even while the screen hard copy is being
printed.
- It is necessary to ensure that the “printer operation status” (bit 7) among the PT
status notify bits is “0” (OFF) before starting printing.
- Once screen printing has been started by operation of the PT status control bit, it
is not possible to stop printing.
- If screen printing is specified during printing by the NT31/NT31C, the screen
printing instruction is ignored.
[Setting]
The PT status control area must be allocated to a word in the host, accordingly, no
special settings are required for printing a hard copy of the screen.