455
Inputting Character Strings
Section 7-15
Stopping the Buzzer
When the buzzer is sounding, it can be stopped in the following ways.
S By operating the PT status control area from the host (page 471).
However, when this method is used, the buzzer will not be stopped unless the
bits for all three buzzer types — continuous, short intermittent, and longintermit-
tent — are set to “0” (OFF).
S By displaying a screen for which no buzzer attribute is set (page 471).
S By pressing a touch key assigned the buzzer stop function (page 472).
By creating a touch switch assigned the buzzer stop attribute (the [
] input key –
control) on a screen for which a buzzer attribute is set, the buzzer can be stopped
by pressing this switch.
To Next Page
Loading...
Need help?
General
