EasyManuals Logo

Omron NT31 User Manual

Omron NT31
707 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #685 background imageLoading...
Page #685 background image
674
Compatibility with Screen Data of Other PT Models
APPENDIX I
Relationship between system program and hardware
Here, relationship between system program and hardware is described.
NT31/NT31C have following models.
NT31-ST121j-E Conventional product
NT31C-ST141j-E
NT31-ST121j-EV1 Version up model of the products above
NT31C-ST141j-EV1
System programs indicated below are installed for the models shown above in the default state. Also, system pro-
grams are supplied with the Support Tool as follows.
S System programs for NT31-ST121j-E/NT31C-ST141j-E (System programs supplied with NT-ZJ3PC1
-EV2/ZJ3DV1-EV2/ZJCMX1-EV2)
S System programs for NT31-ST121j-EV1/NT31C-ST141j-EV1 (System programs supplied with NT-ZJ3MX1-
EV3/ZJCMX1-EV3)
These system programs have mutual compatibility, therefore, they can be installed and used for NT31-ST121j-E/
NT31C-ST141j-E/NT31-ST121j-EV1/NT31C-ST141j-EV1 each.
However, there will be a limitation on function depending on the combination. Refer to the following table.
Hardware
NT31-ST121j-E
NT31C-ST141j-E
NT31-ST121j-EV1
NT31C-ST141j-EV1
System program For NT31-ST121j-E,
NT31C-ST141j-E
The following functions can not be
used
S Analogue meter
S High-definition font display
S Installation of system programs
using memory unit
S Connection to Mitsubishi PLCs
S Memory link
S Window control from the host
S Multiple display of window screens
S Moving a window
The following functions can not be
used
S Analogue meter
S High-definition font display
S Connection to Mitsubishi PLCs
S Memory link
S Window control from the host
S Multiple display of window screens
S Moving a window
* Installation of system programs
using memory unit is possible
For NT31-ST121j-EV1,
NT31C-ST141j-EV1
The following functions can not be
used
S Installation of system programs
using memory unit
S High-definition font display*
All the functions described in this
manual can be used.
* Even though you have Hardware NT31/631 (without V1) and version up the system program of NT31/631
series to “-V1” system program, you can use only “CP437” as font type.
The table above shows only the relationship between the hardware and system program.
For details of the relationship with the screen data created using the Support Tool, refer to NT-series Support Tool
for Windows 95/98 (Ver.3.0) Operation Manual (V053-E1-j).

Table of Contents

Other manuals for Omron NT31

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Omron NT31 and is the answer not in the manual?

Omron NT31 Specifications

General IconGeneral
BrandOmron
ModelNT31
CategoryTouch terminals
LanguageEnglish

Related product manuals