Safety Precautions
18
G5 Series AC Servo Drives With Built-in EtherCAT Communications, Linear Motor Type
The Servo Drive radiator, Regeneration Resistor, Servomotor, etc., may become hot while
the power is supplied or remain hot for a while even after the power supply is cut off. Never
touch these components.
A burn injury may result.
Use the Servomotor and Servo Drive in a specified combination.
Fire or equipment damage may result.
Do not store or install the Servo Drive in the following locations:
• Location subject to direct sunlight
• Location where the ambient temperature exceeds the specified level
• Location where the relative humidity exceeds the specified level
• Location subject to condensation due to rapid temperature changes
• Location subject to corrosive or flammable gases
• Location subject to high levels of dust, salt content, or iron dust
• Location subject to splashes of water, oil, chemicals, etc.
• Location where the Servo Drive may receive vibration or impact directly
Installing or storing the Servo Drive in any of these locations may result in fire, electric
shock, or equipment damage.
Do not carry objects influenced by magnetic fields such as electronics and magnetic
storage media (for example, a watch, personal computer, measuring instrument, magnetic
card, or IC card) closer to the Linear Motor.
Malfunction or failure may result.
Storage and Transportation
When transporting the Servo Drive, do not hold it by the cables.
Injury or failure may result.
Do not overload the Servo Drive. (Follow the instructions on the product label.)
Injury or failure may result.
When lifting a 15 kW or higher Servo Drive during moving or installation, always have two
people lift the product by grasping a metal part. Do not grasp a plastic part.
Risk of injury or product damage.
To Next Page
Loading...
