Omron SYSMAC CS/CJ Series

70
Sequence Input Instructions Section 3-1
3-1 Sequence Input Instructions
Instruction
Mnemonic
Code
Symbol/Operand Function Location
Execution
condition
LOAD
LD
@LD
%LD
!LD
!@LD
!%LD
Indicates a logical start and creates an ON/OFF execution condition based
on the ON/OFF status of the specified operand bit.
Not required
LOAD NOT
LD NOT
@LD NOT
%LD NOT
!LD NOT
!@LD NOT
!%LD NOT
CS1-H, CJ1-H, or
CJ1M CPU Units
only: @LD NOT
%LD NOT
!@LD NOT
!%LD NOT
Indicates a logical start and creates an ON/OFF execution condition based
on the reverse of the ON/OFF status of the specified operand bit.
Not required
AND
AND
@AND
%AND
!AND
!@AND
!%AND
Takes a logical AND of the status of the specified operand bit and the cur-
rent execution condition.
Required
AND NOT
AND NOT
@AND NOT
%AND NOT
!AND NOT
!@AND NOT
!%AND NOT
CS1-H, CJ1-H, or
CJ1M CPU Units
only: @AND NOT
%AND NOT
!@AND NOT
!%AND NOT
Reverses the status of the specified operand bit and takes a logical AND
with the current execution condition.
Required
OR
OR
@OR
%OR
!OR
!@OR
!%OR
Takes a logical OR of the ON/OFF status of the specified operand bit and
the current execution condition.
Required
OR NOT
OR NOT
@OR NOT
%OR NOT
!OR NOT
!@OR NOT
!%OR NOT
CS1-H, CJ1-H, or
CJ1M CPU Units
only: @OR NOT
%OR NOT
!@OR NOT
!%OR NOT
Reverses the status of the specified bit and takes a logical OR with the cur-
rent execution condition.
Required
Bus bar
Starting
point of
block
Bus bar
Starting
point of
block
Bus bar
Bus bar