6
INTRODUCTION
Precautions in using the product
CIDRW System
User’s Manual
INTRODUCTION
Please observe the following precautions to prevent failure to operate, malfunctions, or undesirable effects on
product performance.
■ About installation Site
Do not install this product in the locations subject to the following conditions.
• Place where direct sunshine strikes.
• Place with corroded gas, dust, metallic powder, and salinity.
• Place with condensation due to rapid temperature fluctuations.
• Place with condensation due to high humidity.
• Place where vibration and impact more than being provided by specification are transmitted directly
to main body.
• Place with spray of water, oil, and chemical medicine.
• The working temperature is within the range stipulated in the specifications.
■ About depositoty Site
• Please follow the save ambient temperature / humidity, and keep this product.
■ About wiring
• Use the power supply voltage specified in this cocument.
• Ensure correct polarity when connecting to the +/- power supply terminals.
• Do not run high-voltage lines and power lines though the same conduit.
• To avoid static-induced failure, wear a wrist band or equivalent means to release a static charge
before touching a terminal or a signal line within a connector.
• When you put on and take off a CIDRW head, please do not add excessive power to a connector.
• Please connect the correct CIDRW head to the amplifier unit.
■ About cleaning
• Use alcohol to clean this product.
• Never use an organic solvent such as thinner, benzene, acetone or kerosene, as it will attack resin
components or case coating.
■ Power and Graound Cables
• Use an appropriate ground. An insufficient ground can affect this product operation or result in dam-
age to this product.
■ About the communication range and time
• Do the communication test with Transponder in the installation environment because the metal,
noise and ambient temperature around CIDRW head damage to the communication range and time.
• Install CIDRW head and ID tag in the appropriate distance because the communication range can
change by the difference of ID tag specifications.
Precautions for Correct Use
To Next Page
Loading...
Need help?
General
