10
2.1 Disclaimer
Your engraver may diff er somewhat from those shown in this manual due to options, updates, etc. Please contact us
if your engraving machine came with an outdated manual or if you have any other questions.
2.2 General Safety Instructions
• Your device should come with instruction labels in the following locations:
If any of these labels is missing, illegible, or becomes damaged, it must be replaced.
• Use this laser engraving device only in accordance with all applicable local and national laws and regulations.
• Use this device only in accordance with this instruction manual and the manual for the engraving software
included with it. Only allow this device to be installed, operated, maintained, repaired, etc. by others who have
also read and understood both manuals. Ensure that this manual and the software manual are both included with
this device if it is ever given or sold to a third party.
• DO NOT operate continuously for more than 4½ hours. Stop for at least 30 minutes between uses.
• DO NOT leave this device unattended during operation. Observe the device throughout
operation and, if anything seems to be operating strangely, immediately cut off ALL power to
the machine and contact either our customer service or your dedicated repair service. Similarly,
ensure the device is FULLY turned off (including by means of the emergency stop switch) after
each use.
• DO NOT allow minors, untrained personnel, or personnel suff ering from physical or mental impairment that
would aff ect their ability to follow this manual and the software manual to install, operate, maintain, or repair
this device.
• Any untrained personnel who might be near the device while it is in operation MUST be informed that it is
dangerous and fully instructed on how to avoid injury during its use.
• Always keep a fi re extinguisher, water hose, or other fl ame retardant system nearby in case of accidents. Ensure
that the local fi re department's phone number is clearly displayed nearby. In the case of a fi re, cut electrical
power before dousing the fl ame. Familiarize yourself with the correct range for your extinguisher before use.
Take care not to use the extinguisher too close to the fl ame, as its high pressure can produce blowback.
2. Safety Information
To Next Page
Loading...
Need help?
General
