CONTROL
SYSTEM
Due to the wide variety of
uses
to
which
these
engines
are
adapted,
operating controls are not supplied
with
the majority of
these
engines. The
engines
in most
cases
are
used
for prime power to
operate
other manu-
facturers equipment. Installation nearly always differs.
Therefore the manufacturer or fabricator generally pro-
vides a control, or control components for engine,
incorporated in a control for the complete unit.
Operating controls are furnished on
some
models when
the customer can use standard controls. They are
mounted on the
rear
cylinder air housing. Refer to the
appropriate
wiring
diagram.
For
basic
engine controls and optional equipment
controls
which
are mounted on the engine, instructions
are included in the related groups in the manual.
MAINTENANCE
Periodically
check all connections and
contacts
in the
control
system to be
sure
they are
tight
and clean.
45
To Next Page
Loading...
Need help?
General
