CLUTCH
GROUP
(Optional Equipment)
REF.
NO.
PART
NO.
1
I90D25I
2
515-6
3
805-19
4 I90C252
4 I90C253
5
I90A254
6
I90P258
7 800-74
8
850-55
QTY.
USED
PART
DESCRIPTION
• Housing, Clutch
Key, Clutch
Bolt, Place (3/8-16 x 1-1/4 ") -
Housing to Engine
Flange, Drive - To Adapt
Rockford Clutch
Flange, Drive - To Adapt Twin
Disc Clutch
Washer, Flat
•Clutch Assembly, Rockford -
PTA - 5822
Screw (7/ 16-14 x 1-3/4 ") -
Flange Mounting
Washer, Lock (7/16 ")
* For component parts, contact a Rockford Dealer.
CONTROL
GROUP
(Optional)
NOTE:
Parts in this group apply to engine with factory
mounted controls on rear cylinder air housing. Due to the
wide variety of uses to which these engines are adapted,
operating controls are not supplied with the majority of these
engines. The engines in most cases are used for prime
power to operate other manufactures equipment. Installation
nearly always differs. Therefore, the manufacturer or
fabricator generally provides a control, or control components
for engine, incorporated in a control for the complete unit.
Contact them for control parts.
REF.
NO.
I
2
3
4
PART
NO.
308-198
308-7
308A28
332-592
322-69
322-17
QTY.
USED
PART
DESCRIPTION
Switch,
Start
Switch,
Decompression Sole-
noid
Switch,
Glow Plug
Jumper, Terminal. Start Switch,
Engines with Oil Pressure
Switch
Light, Pilot (Red), Engines
with Charging Alternator
Lamp,
Pilot Light, Engines
with Charging Alternator
SERVICE KITS AND MISCELLANEOUS
NOTE:
For other kits, refer to the group for the part in question.
PART
QTY.
PART
NO.
USED
DESCRIPTION
98CI 100
1
Decal Kit
I68K85
1 Gasket Kit, Plant
OVERHAUL KIT, PLANT
522K200
1 Spec A thru R
522K249
1 Begin Spec S i
525PI37
1
Paint, Touch-up Enamel (Green)
16 Ounce Pressurized Can
62
To Next Page
Loading...
Need help?
General
