CLUTCH
GROUP
(Optional Equipment)
1 6
6 °CJB
REF.
NO.
PART
NO.
I90D25I
515-6
805-19
I90C252
I90C253
I90A254
I90P258
I50A9I8
QTY.
USED
PART
DESCRIPTION
I Housing, Clutch
1 Key, Clutch
4 Bolt, Place (3/8-16 x
1-1/4")
Hsg.
to Eng.
I Flange, Drive - To Adapt Rock-
ford Clutch
I Flange, Drive - To Adapt Twin
Disc Clutch
I Washer, Flat
I 'Clutch Assy. Rockford - PTA-
58 22
I • ' Screw, Flange Mtg.
* - For component parts, contact a Rockford Dealer.
CONTROL
GROUP
(Optional)
NOTE:
Parts in this group apply to engine with factory
mounted controls on rear cylinder air housing. Due to the
wide variety of uses to which these engines are adapted,
operating controls are not supplied with the majority of these
engines. The engines in most cases are used for prime
power to operate other manufactures equipment. Installation
nearly always differs. Therefore, the manufacturer or
fabricator generally provides a control, or control components
for engine, incorporated in a control for the complete unit.
Contact them for control parts.
REF.
NO.
I
2
3
4
PART
NO.
308-198
308-7
308A28
332-592
322-69
322-17
QTY.
USED
PART
DESCRIPTION
Switch,
Start
Switch,
Decompression Sole-
noid
Switch,
Glow Plug
Jumper. Terminal. Start Switch,
Engines with Oil Pressure
Switch
Light, Pilot (Red), Engines
with Charging Alternator
Lamp,
Pilot Light, Engines
with Charging Alternator
SERVICE
KITS
AND
MISCELLANEOUS
NOTE:
For other kits, refer to the group for the part in question.
PART
NO.
QTY.
USED
PART
DESCRIPTION
98CI 100 I Decal Kit
I68K85 I Gasket Kit, Plant
OVERHAUL KIT, PLANT
522K200 I Prior to Spec S
522K249 I Begin Spec S
525PI37 I Paint, Touch-up Enamel (Green)
16 Ounce Pressurized Can
58
To Next Page
Loading...
Need help?
General
