POWER button is the red button aviation socket at side. It can be used for power on and off.
Display Info and Icons
#1 System date and time
#2 GPS positioning status when showing icon , it means GPS is not opened or disconnected; when icon
turns into , it means GPS signal is in normal connection and the system will automatically update time and
record coordinate info.
#3 Volume icon, use menu or buttons to set. The latter half of icon shows volume level.
#4 Brightness icon. Use menu or buttons to set. The latter half of icon shows brightness level.
#5 Battery status icon
#6 On upper center of screen, VM means the speed measured. “+” before numbers means the speed of vehicle
head; “-” means the speed of rear.
#7 Digital zoom function. To work properly, this function needs be opened at image settings page.
#8 Aiming rectangle icon. Use central circle inside rectangle to show laser aiming area.
#9 Mode: It shows current speed measurement and image capture mode. Use buttons or menu to set.
#10Speed limit: It shows the speed value no less than current image capturing needs.
#11 Distance: it means current distance measured.
#12 Speed: it means the speed measured.
System Starting-up and Power-off
Power On
Please confirm that battery handle and SD card have been installed. Press red POWER button at side for a
second and release. The system enters booting procedure and display. In the process of starting up, the system
will automatically check errors. If errors occur, it will show the error message or code, base on the error message
to address accordingly or contact local distributor.
When self-test dialogue box occurs, current firmware version will also be shown at top of touch screen.
Standby: enter image/video replay.
Move cursor up and down. When standby, it can be used to adjust
volume. There are 4 levels of volume.
To Next Page
Loading...
Need help?
General
