Onkyo TX-SA806

103
Zone 2—Continued
Adjusting the Volume for Zone 2
Muting Zones
Adjusting the Tone and Balance of Zone 2
Notes:
• Only analog input sources are output by the ZONE 2
PRE OUT and ZONE 2 L/R speaker terminals. Digital
input sources are not output. If no sound is heard when
an input source is selected, check if it’s connected to
an analog input.
•
While Powered Zone 2 is being used, listening modes
that need surround back speakers (i.e., Dolby Digital EX,
DTS-ES, and THX Ultra2 Cinema) are unavailable.
• While Zone 2 is on, u functions will not work.
• You cannot select different AM or FM radio stations
for your main room and Zone 2. The same AM/FM
radio station will be heard in each room. For example,
if you have an FM station for the main room, that sta-
tion will also be used in Zone 2.
• Zones can also be unmuted by adjusting the volume.
• The Zone 2 level, balance, and tone functions have no
effect on the ZONE 2 PRE OUT when the “Zone2
Out” setting is set to “Fixed” (page 101).
1
AV receiver/
AV amplifier
On the AV receiver/AV amplifier,
press the [ZONE 2] button, and
then use the [LEVEL] button.
2
Use the Up [r] and Down [e]
buttons to adjust the volume.
Remote
controller
On the remote controller, press
the [ZONE 2] button, and then
use the VOL [q]/[w] button.
Remote
controller
On the remote controller, press
the [ZONE 2] button, and then
press the [MUTING] button.
To unmute a zone, on the remote
controller, press the [ZONE 2]
button, and then press the [MUT-
ING] button again.
1
AV receiver/
AV amplifier
On the AV receiver/AV amplifier,
press the [ZONE 2] button.
2
Press the AV receiver/AV ampli-
fier’s [TONE] button repeatedly to
select “Bass”, “Treble” or “Bal-
ance”.
3
Use the Up [r] and Down [e]
buttons to adjust the Bass, Tre-
ble or Balance.
• You can boost or cut the Bass or Tre-
ble from –10 dB to +10 dB in 2 dB
steps.
• You can adjust the balance from 0 in
the center to +10 dB to the right or
+10 dB to the left in 2 dB steps.
ZONE 2 TONE
,
TX-SR806_En.book Page 103 Monday, August 4, 2008 10:25 AM